DG Display Showcase Manufacturers & Suppliers - 25 Years DG Master of Custom Display Showcase +8613610079233 sales@degreefurniture.com
Solid wood is a natural material. When it is still log is relatively rough, it must be made through a series of processing to make a beautiful solid wood jewelry showcase, solid wood furniture and other finished products. When the wood is cut down from the mountain, the first thing to do is dry.
The wood has the characteristics of porous, easy to absorb water and drainage, and has the characteristics of dry shrinkage. The phenomenon, so the new wood needs to be dried until 8%to 12%of the water content, so the coating can be covered. Therefore, the drying method of the wood is naturally dry and low -temperature drying.
Although the surface of the jewelery display cabinet is generally planed or polished, there are always some wooden fiber residual surfaces that are not completely separated. Once they absorb moisture or solvents, they will wet and expand their hands. Sex, leave the covered coating to leave some unpleasant small white points, so the burrs must be removed before the coating is covered.
As long as the general wood products are grinded several times, the high -end wooden jewelry showcases can be treated as follows: jewelry showcases (1) sparse worm paint on the surface (insect glue: alcohol = 1: 71: 71: 71: 71: 71: 71: 8), so that the burrs can not only be erected, but also crispy, it is easy to use sand to remove clean. (2) Wipe the surface with a wet cleaner rag, so that the burrs absorb water and swell and erected. After the surface is dry, use fine sandpaper or old sandpaper to polish.
If you add some bone glue in the water, the effect is better. (3) Adopt a fire method, that is, brush a thin layer of alcohol with a pen, and immediately lit with the fire. After the burden of the fire becomes hard and crispy, it is easy to remove the sand.
This method is only applicable to the plane. .
jewelry showcase manufacturers